Features,
Alarm reset available from a front panel key-switch
Trial Evacuation key-switch
Fire & Defect C/O relays with Fire relay Isolate switch
Automatic Alarm Verification Facility (AVF) provides substantial
protection against transient false alarm activation
Supervised bell circuit with 10 kΩ EOL resistor
Maximum of two 20 Watt 100 Vrms line amplifiers with voice
evacuation message
‘Battery Absent’ detection circuitry
Earth leakage supervision
Integrated Alarm and Defect piezo for audible warning
On-board System ‘Defect’ LED indicates source of fault
Door Interlock
Brigade ‘Isolate’ and ‘Test’ switches
Electrically isolated interface to an alarm transmitter (SGD)
DBA mode ‘Non Latching, Bell Only’ configuration available (on Circuit 4)
Automatic daily load test with automatic ‘Battery Absent’ detection circuitry

• Sleek low profile appearance
• Low current consumption
• Ideal for use of various applications for example fire alert or to signal class change
• Comes complete with an Allen key for easy installation and a tamper resistant hex bolt

Features,

AW-CFP2166 series conventional fire alarm panel is designed based on EN54 part 2&4 standard.
2. It is modularized design, the panel can extend from 1 zone to 32 zones easily.
3. It has 2 level control mode by a lock
4. It has 24VDC and 5VDC power supply output.
5. It has FIRE and FAULT signal output.
6. It has 2 general sounders output.
7. Each zone has 1 circuit detectors input.
8. Each zone can be disable by a button.
9. It has RESET button to reset the panel.
10. It has SILENCE button to stop BUZZER and SOUNDERS.
11. It has EVACUATE button to start a manual fire alarm immediately.
12. It has battery low protection function, when battery voltage lower than 21VDC, battery will be cut off automatically until the mains power is on.